Nordson ProBlue 4 Hot Melt Stitching and Dotting Upgrade Package

Upgrade Your Existing Nordson ProBlue 4 Equipment to a Hot Melt Dotting System

Quickly and affordably upgrade your Nordson ProBlue 4 bulk tank system to a hot melt stitching and dotting system and use up to 50% less adhesive. The installation takes under 3 hours and does not require adding or changing your Nordson ProBlue 4 tanks or hoses.

Hotmelt.com will provide you pricing on upgrading your system along with a savings calculator to upgrade to a dotting system. 

Nordson ProBlue 4 Stitching and Dotting Upgrade Details

• No new tank required
• No new hoses required
• Total installation time less than 3 hours
• Local on-site installation available

Benefits of Nordson ProBlue 4 Hot Melt Dotting Upgrade

• Use up to 50% less hot melt adhesive
• No expensive compressed air required
• Increased safety using pneumatic dispenser
• Longer life guns and modules - up to 1 billion cycles
• Same or improved bond strength
• Allows for faster line speeds 

* Nordson is a registered trademark of the Nordson coproration. Any use of the Nordson name is for comparison purposes only.

Nordson ProBlue 4 Hot Melt Stitching and Dotting Upgrade Package Specs

Hot Melt Dotting Glue Gun Specs

• Electromagnetic hot melt application head for glue beads and dots
• Up to 10 times longer service life, compared to electro-pneumatic hot melt application heads
• Reduction of operating noise by 30 dB – compared to electro-pneumatic hot melt application heads – to 65 dB
• Cost savings through elimination of the compressed-air supply
• Suitable for use with non-hhs systems with a commercially available PLC
• Plug-in module
• Compact design
• Thermal insulation
• Integrated over-temperature cut-out
• Less adhesive is required for dot application

Nordson ProBlue 4 Hot Melt Stitching and Dotting Upgrade Package Resources

• hhs Baumer Tesla Go Data Sheet