Our 8 Favorite Hot Melt Glue Gun Kits of 2018
At Hotmelt.com, we sure have seen a lot of hot melt glue gun kits over the years. But ...Read More
OVERSTOCK! Buy Graco InvisiPack at Cost for Limited Time Only Shop Now
The 3M Polygun II Hose Kit (Part # 9221) contains the hose, elbow and swivel filter. We recommend that if you have 16-20 3M PG II glue guns in use you should always keep one hose kit in stock for repairs.
Disconnect electrical and compressed air service. To replace applicator handles, first follow “Handle Disassembly Instructions.”
Next remove the electrical wiring from the terminal strip on the left handle, replacing them to the same terminals on the replacement. The right half of the handle is removed by removing the four Phillips head cap screws.
Next remove the electrical wiring from the terminal strip and reassemble these to the replacement right half handle. Lift the switch out of its slot in the handle and replace it in the new handle.
Replace the trigger and trigger pin at this time. Using reverse procedure, reassemble the right handle half, then the left. Be sure all the electrical wires are in place and are not being pinched.
Our experts know the 3M PG II glue gun and adhesives backwards and forwards. Questions? Contact us about gun repair, adhesive recommendations and more.
Today we want to highlight one of our favorite workhorses in the hot melt category: In...Read More